Slide the diverter in.
Roof water diverter installation.
I need to prevent this problem as i do not want a wet basement.
Exposure at the other end to create a drainage pitch.
Order your diverter online and receive within a week.
Roof rain diverter installation steps sand underside of flashing with 80 grit sandpaper to help paint adhere.
To install a rain diverter on your roof.
It prevents rain water from cascading on the inside corners of the shingle roof.
Using a pry bar or putty knife loosen the second row of shingles up from the edge of the roof where the diverter will be located.
Slide one end of the diverter tight to the bottom of the shingle tabs and leave a 1 in.
Our diverter comes fully assembled and ready to install by qualified contractor.
Lift the shingles to nail the.
I have water running off the side of my roof as evidenced by the mud splashed up on the side of my house and a water channel in my flower bed below.
Slide the diverter under the shingles.
A rain or water diverter will keep a doorway.
Loosen up the shingles by.
Can i install the rain diverter on the side of a roof and if i do how do i get the water back into the gutter.
Thick bead of clear silicone caulk on the underside of the drip edge lift the shingle tabs up slightly and slide the diverter under the tabs.
Use flat pry bar to loosen stuck roof.
The edges of product s body are bended inside to prevent water back up under roof shingles.
Start by cutting the flashing with tin snips about 2 3 feet longer than the doorway you want to protect.
Spray paint bottom surface and up turned edge of flashing to match color of roof.
Installing a rain diverter on your roof is useful if you have a place where water runs and you don t want it to.
A drop of 1 is plenty for a 6 diverter.
Diverter is made from 24 gauge aluminum that is rust resistant and flexible to accommodate different roof angles.
Slide the long side of the diverter under the shingles leaving the lip of the diverter hanging out.
Eliminates the hazard of owerflowing water and ice and prevents dangerous slip and fall accidents.
Roof valley rain water diverter is the only product on the market that solves the problem of overflowing water on an a roof.
Climb a sturdy ladder and locate the second row of shingles closest to the roof edge.
Next carefully break the seal on a row of shingles above the doorway with a flat pry bar or putty knife.
Cut flashing in half using aviation snips.
How to install a rain diverter on a roof 1.